快三怎么玩大小单双稳赚-快三怎么推算和值大小单双-玩快三大小单双稳赚技巧

7*24Hours for you

15967710202/0577-66081118

company newsCurrent Pocation:homecompany news

How to prevent foaming in polyurethane foaming machine

How does polyurethane foaming machine prevent cavitation

快三怎么玩大小单双稳赚-快三怎么推算和值大小单双-玩快三大小单双稳赚技巧1. Strictly control the ratio and injection amount of the original liquid

快三怎么玩大小单双稳赚-快三怎么推算和值大小单双-玩快三大小单双稳赚技巧Control the ratio of black material, combination polyether and cyclopentane. Under the condition that the total injection volume remains unchanged, a large proportion of black material will lead to cavitation, a large proportion of white material will lead to soft bubbles, a large proportion of cyclopentane will lead to swelling bubbles, and a small proportion will lead to cavitation. The proportion of black and white material is maladjusted, there will be uneven mixing, foam shrinkage phenomenon.

Injection quantity how many should be based on technical requirements of the injection quantity below will appear when the technological requirements of bubble volume molding low density, low intensity, even not filled with a dense cavitation will appear when injection amount above process requirements rising bubble and bubble leakage phenomenon, casing deformations can occur (the door) 2 polyurethane foaming machine temperature control is a key to solve the cavitation at high temperature control violent reactions are less prone to inject large housing bubble fluid properties inhomogeneity, began the injected fluid chemical reactions have occurred, the viscosity increases rapidly, after the injection of bubble liquid has not responseCause after injection of bubble liquid can't push the first injection of bubble liquid at the forefront of enclosure foaming process, a box body local cavitation should be done before black and white material in the foaming temperature, control the foaming temperature in 18 ~ 25 foaming equipment preheating furnace temperature should be controlled in 30 ~ 50, foaming mould temperature should be controlled between 35 and 45 foaming mold temperature too low, bubble liquid is illiquid, curing time is long, incomplete reaction, a cavity;Foaming mould at high temperature, the plastic tank heat deformation, soaking liquid of violent reactions must therefore be strictly control the foaming mold temperature and environmental temperature of the foaming furnace especially during the winter, the morning line is a must for foaming mould preheating furnace foaming furnace and housing more than 30 minutes preheating and the hydrodynamic summer foam after a period of time shall be of foaming system for cooling polyurethane foaming machine low pressure foaming machine control of black and white cyclopentane mixed uneven, polyurethane foam density uneven performance for local big bubble bubble crazePartial softening of foam: white, yellow or black streaks appear on the foam. The injection pressure of the foam deflating foaming machine is 13~16MPa


王中王最快开奖王中王-王中王马王中王资料大全-王中王资料大全枓大全特 加拿大28百分百中算法-pc加拿大28在线预测网站-加拿大28开奖结果 宝马论坛130222-宝马论坛118论坛-133222宝马论坛爆富六肖 金多宝论坛四肖八码王-金多宝高手论坛www |995澳门论坛六肖六码开奖|995澳门论坛六肖六码生肖板 133222宝马论坛爆富六肖-宝马论坛130222-宝马论坛118论坛